B&K 2250 Light Manual de usuario descargar pdf (Pagina 167)

CHAPTER 14

Reverberation Time Software (Optional Module)

155

14.3 Displaying the Results

The Reverberation Time Measurement screen includes three tabs at the bottom: Overview,

Spectrum and Decay. The tabs allow you to choose different ways of displaying the

measurement results:

• Overview: Shows the measurement positions in a table – one position per row. Use this to

get an overview of your measurements, to include/exclude positions from the spatial

average of all positions in the room, and to manage annotations/signal recordings at the

positions

• Spectrum: Shows the reverberation spectra graphically, or as a table, for one position, or for

the room average. Alternatively, it can show the instantaneous sound pressure level while

measuring

• Decay: Shows the reverberation decay at a single frequency, for one position, or for the

room average

14.3.1 Overview

The Overview tab shows the measurement positions in a table – one position per row.

Fig.14.6

Overview tab

Status Field

The Status Field consists of three lines (see Fig.14.6) – the first two lines of information are

common to the status lines in the Sound Level Meter and Frequency Analyzer (see Chapter 4).

Note: The first line of the Status Field might also contain a smiley, indicating the quality of the

room (the spatial average of all positions). See the description of smileys in the following

paragraph and section 14.5.

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 331 332

Sin comentarios

B&K 2250 Light Manual de usuario Pagina 167