B&K 50 Series II Manual de usuario descargar pdf (Pagina 61)

4. Connect the external analog control pins from the rear panel of the instrument to your

voltage control source as shown below:

Figure 13 - Analog Control Setup

5. Set the instrument to CC mode and enable the input to begin controlling with the

external voltage source.

Do not connect more than 30 V into the external program terminal pins or damages may

occur.

External Input On/Off Control

The electronic load’s input can be enabled (ON) or disabled (OFF) via the external control pins

labeled ON and ground pin ( ).

Enable (ON) input: Short the two pins together, as shown below:

Rear Panel Terminals

0 – 10 V

External Voltage Source

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 101 102

Sin comentarios

B&K 50 Series II Manual de usuario Pagina 61