B&K 50 Series II Manual de usuario descargar pdf (Pagina 37)

The setup parameters are: Range, High (Voltage limit), and Low (Voltage limit). Use the

key to select each parameter, and use the numeric keypad to change the value. Press

to confirm the change.

Range

Use the numeric keypad to change the range. This value will also act as a limit to how much

resistance the load can be configured to. The adjustable ranges vary depending on the model.

See specifications for details.

High

This parameter refers to the voltage high limit for the automatic test mode. During automatic

test mode, the device under test (DUT) must be operating below the configured value for the

test to PASS upon completion. If the DUT operates above the configured value, the test will FAIL

upon completion.

Note: This parameter is used for Automatic Test Function ONLY.

Low

This parameter refers to the voltage low limit for the automatic test mode. During automatic

test mode, the DUT must be operating below the configured value for the test to PASS upon

completion. If the DUT operates above the configured value, the test will FAIL upon completion.

Note: This parameter is used for Automatic Test Function ONLY.

Constant Power (CW) Mode

In this mode, the electronic load will consume a constant power. When input voltage increases,

the input current will decrease, while power (P = V*I) will remain the same.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 101 102

Sin comentarios

B&K 50 Series II Manual de usuario Pagina 37