B&K 50 Series II Manual de usuario descargar pdf (Pagina 41)

Configure Power-On State

The initial Power-On state of the load can be configured by following the steps below:

1. From the SYSTEM menu, select Power-On and press .

2. There are two options:

Rst(Def) – Factory Default.

Sav0 – Settings before last power up. Recalls the settings saved to “0” memory location.

3. Select the settings you want during power up, and press to save changes.

4. To exit the menu at any time, press twice.

Load On Knob

This setting controls the behavior of the knob.

1. From the SYSTEM menu, select Knob and press .

2. There are two options:

Update(default) – Real time update.

Old – No update (when turning load ON/OFF, original value before use of rotary knob

will be set)

3. Select the settings you want during power up and press to save changes.

4. To exit the menu at any time, press twice.

Configure Trigger Source

The trigger function is used to initiate the start of a program in list mode and also as a toggle for

transient mode. The trigger source can be set so that users can send a trigger from the front

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 101 102

Sin comentarios

B&K 50 Series II Manual de usuario Pagina 41