B&K 2250 Light Manual de usuario descargar pdf (Pagina 80)

Hand-held Analyzer 2250 Light – User Manual

Table 8.2 Content of Notification

Note: some of the information listed above may not be available, depending on the conditions

when the notification was sent, e.g., no measurement values will be available immediately after

a power on.

8.4.2 Text/SMS Notifications

Notifications via SMS (text message) can be used if you have connected a

GSM/GPRS/EDGE/HSPA modem to the analyzer (see section 8.2.2) and set Modem to

Disabled (a text message cannot be sent if the modem is set to GPRS/EDGE/HSPA Dialup).

In addition to sending SMS notifications initiated by alarms, you can send an ‘INFO’ SMS to

the analyzer and ask for an SMS notification, after which you will get a notification within 30

seconds.

You need to setup a Phone Number in Preferences, Notifications, SMS and set Active to Yes for

the SMS. You can also add a Name for the number for easier identification.

You can setup two individual SMS phone numbers for sending the SMS notification to two

recipients.

Set Notification to SMS and a notification will be sent by SMS to the active phone numbers,

when any of the alarm conditions are met, or if the analyzer receives an ‘INFO’ SMS.

You can test the system by tapping on the Main Menu icon and selecting “Send

Notification via SMS”.

Note 1: Two to three text messages will be used to send the complete notification – depending

on the content and language settings.

Note 2: Text messages cannot be sent or received while the analyzer is connected to BZ-5503

or online display.

Information Type Content

Reason for notification ‘Test’, ‘Alarm’ or ‘Status’ followed by a short description

Time of notification Date and Time

Instrument ID Serial No. and Location

Status of current Disk Free memory / Total memory

Status of Internal Battery Full, High, Low, Critical, Charging or Unknown

Measurement Status (if available) Running, Paused or Stopped

Latest CIC Result (if available) Passed, Background noise too high, Ratio outside tolerances,

Ratio deviates from Ref., Undefined Ref., or Undefined

Current value of LAF (if available) The value

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 211 212

Sin comentarios

B&K 2250 Light Manual de usuario Pagina 80